feat(config): increase key repeat rate to 50Hz and adjust tap-hold term to 150ms

dot_config/hypr/input.lua

@@ -1,12 +1,12 @@
 -- Keep only your personal input overrides here. Uncommented settings below
 -- replace Omarchy's defaults.
 
--- Key repeat: Omarchy's 250ms / 40Hz is left alone. 200 / 50 was tried and
--- felt too fast; the "typing lag" it was meant to fix turned out to be the
+-- Key repeat: Omarchy's 250ms delay kept, rate raised 40 -> 50Hz. 200 / 50 was
+-- tried and felt too fast; the "typing lag" it was meant to fix turned out to be the
 -- Pilot W-Corne's firmware (55d4:0461, Vial/QMK over a 2.4GHz dongle)
 -- resolving its MT(LGUI,SPC) / MT(LCTL,SPC) thumb keys as holds the moment
 -- another key went down. Fixed on the board itself: Vial QMK Settings ->
--- Tap-Hold -> "Ignore Mod Tap Interrupt" (qsid 8 bit 1), tapping term 200ms.
+-- Tap-Hold -> "Ignore Mod Tap Interrupt" (qsid 8 bit 1), tapping term 150ms.
 --
 -- The rest of the keystroke path was checked and is already optimal: the
 -- dongle advertises bInterval=1 (1000Hz polling), udev pins power/control=on
@@ -14,6 +14,12 @@
 -- 5GHz, and render:new_render_scheduling is off (no triple-buffer frame).
 -- Remaining latency is the 60Hz Studio Display refresh and the fcitx5
 -- input-method hop (see omarchy-fcitx5.service), neither an input option.
+hl.config({
+  input = {
+    repeat_delay = 250,
+    repeat_rate = 50,
+  },
+})
 
 -- Keyboard layout and options.
 -- See https://wiki.hypr.land/Configuring/Basics/Variables/#input